- Help centre
- Handover and aftercare
Defects by plot
Aftercare by plot shows each plot's handover and every defect reported on it. It is for aftercare and site managers.
Steps
- Open the project, then Aftercare. Each plot has its own section.
- For a plot not yet handed over, fill in Handed over on, Home demonstration done on and Keys handed on. Add the Gas meter reading, Electricity meter reading and Water meter reading. Select Record handover. The defects period starts.
- Select Send buyer the signing link. The buyer signs from the link in their email. Until then the page reads Buyer has not signed.
- In the defects table, set the Priority. The Target time follows the priority, and Overdue shows in red once it is passed.
- Choose Assign to order… to pass the defect to the subcontract order responsible. That trade is emailed its link.
- Enter the Appointment date once a visit is booked.
- When the trade has fixed it, the status reads Fixed. Select Confirmed by buyer once the buyer agrees. The defect becomes Closed (buyer confirmed).
- A fixed defect that was a trade's fault can be charged back to that order from the same row.
Defect statuses run Reported, Booked, Fixed, Closed (buyer confirmed).
What happens in Xero
Nothing is sent to Xero for handover or for fixing defects. A charge back is recorded against the trade's order in Construct365.